Confirming your payment

Skip to content

Competency-Based Questions (CBQ) · Question 65 of 80

Reading a tensile test.

Question 655 marksHard

Reading a tensile test. A metal specimen is pulled in a testing machine and its stress–strain curve is recorded, as shown (part (b) enlarges the start of the curve). The straight part OB has a slope of Y=200 GPaY = 200\ \text{GPa} and ends at B (strain 0.001250.00125, stress 250 MPa250\ \text{MPa}). Between B and C (strain 0.0200.020, stress 300 MPa300\ \text{MPa}) the curve may be taken as a straight line. The highest point D is at a stress of 400 MPa400\ \text{MPa} (strain 0.120.12), and the specimen breaks at E (strain 0.180.18, stress 330 MPa330\ \text{MPa}). When the load is removed from any point beyond B, the specimen unloads along a straight line parallel to OB, and if it is loaded again it goes back up along that same line until it rejoins the original curve.

Class 11 Physics Mechanical Properties Of Solids Question 65

(i) State the yield strength and the ultimate tensile strength of the metal, and check that the slope of OB agrees with Y=200 GPaY = 200\ \text{GPa}.

(ii) A second specimen is loaded only up to C and then unloaded completely. How much of its strain does it recover, and what permanent set is left?

(iii) This second specimen is now loaded again. Up to what stress does it now behave elastically, and what is its Young's modulus during this reloading? Has the treatment made the metal stiffer, or only raised its elastic limit?

(iv) A third specimen is loaded only to 200 MPa200\ \text{MPa} and unloaded. What strain does it recover, and what permanent set does it have?

(v) Is the metal brittle or ductile? Give two pieces of evidence from the curve, and say why such a metal suits a car body panel better than glass would.