(i) The force acts along the top face, of area A=0.30×0.30=0.090 m2:
σs=AF=0.0909.0×103=1.0×105 N m−2
Shearing stress =1.0×105 N m−2.
(ii)
θ=Gσs=1.0×1061.0×105=0.10
Shearing strain =0.10, so the sides tilt through 0.10 rad=0.10×π180∘=5.7∘.
(iii) The shearing strain is Δx/L, where L=0.050 m is the thickness of the pad:
Δx=θL=0.10×0.050=5.0×10−3 m
The top of the pad moves 5.0 mm relative to its bottom.
(iv) For steel,
θsteel=84×1091.0×105=1.19×10−6,Δx=1.19×10−6×0.050=5.95×10−8 m
A steel block would move only about 6.0×10−8 m, some 84 000 times less than the rubber pad.
(v) The stress and so the strain are unchanged (the face area is the same), but the displacement is θL with L doubled:
Δx=0.10×0.10=1.0×10−2 m
The top would move 10 mm.
The deck of a bridge is pushed sideways by braking and accelerating vehicles and by wind. A rubber pad, with its very small shear modulus, lets the deck move a few millimetres elastically under these forces and then springs back. The force is passed to the pier gently, and the deck and pier are not jolted. A steel block would allow almost no movement (about 10−7 m), so every sudden push on the deck would be passed straight into the pier and its foundations as a sharp jolt. Choosing the thickness of the pad lets the designer set how much the deck can move.