(a)
I=VP=2201500≈6.82A
R=PV2=15002202=150048400≈32.3Ω
(b) The cord and the element are in series, so the current I is the same in both. The heat produced in any part of the circuit is H=I2Rt. With I and t the same, the heat produced in each part depends only on its resistance.
The thick copper cord has a very low resistivity and a large area of cross-section, so its resistance is a small fraction of an ohm and almost no heat is produced in it. The long, thin nichrome coil has a high resistivity and a resistance of about 32.3Ω, essentially the whole resistance of the circuit, so practically all the heat is produced there.
(c) With I≈6.82A and R=0.5Ω:
P=I2R=(6.82)2×0.5≈23W
H=Pt=23×60≈1.4×103J
About 1400J of heat is produced in the cord every minute, about 23W wasted, compared with about 90000J in the element. The rod still heats the water, but the thin cord carries a large current and keeps getting hot along its whole length. Its insulation can soften or melt, and the live and neutral wires inside could then touch. That is why the cord of a high-power appliance must be thick, with a low resistance.
(d) The element still produces heat at 1500J every second, whether it is in water or not. In water, this heat is carried away into the water as fast as it is produced, so the element stays at a safe temperature. In air, very little of the heat is carried away, so it builds up in the small mass of the coil and its temperature keeps rising. Within a short time the coil becomes far hotter than it was designed for, and it melts or burns out.
So it is the removal of the heat by the water, not a change in the heat produced, that keeps the element safe.