(a) The heat produced in a conductor is given by the heating effect of current:
Plost=I2R=(10)2×2=100×2=200 W
(b) The cable is the same, so R is still 2 Ω. Only the current has changed:
Plost=I2R=(1)2×2=2 W
(c) The waste has fallen by a factor of
2200=100
Why cutting the current by 10 cuts the loss by 100. The loss depends on the square of the current:
Plost=I2R
so dividing the current by 10 divides the loss by 102=100. Nothing about the cable changed at all — the same copper, the same 2 Ω.
Why high voltage is the way to do it. The power actually delivered is
P=VI
so the same power can be sent either as a large current at a low voltage or as a small current at a high voltage. Since the loss depends only on the current and the cable, choosing the high-voltage option makes the transmission far more efficient. Doubling the voltage halves the current and quarters the loss; raising it tenfold cuts the loss a hundredfold.
And this is why the choice is not free. High-voltage lines need tall pylons, long insulators and wide clearances, and the voltage must be transformed back down before it can safely enter a house. The engineering exists entirely to keep that I2R term small over hundreds of kilometres.

The loss goes as the square of the current, so the current is what you cut.