Confirming your payment

Skip to content

Opening your dashboard

Class 7 Science Chapter 3 Electricity: Circuits & Components: Practice Questions

20 questions on Chapter 3, each worked through on its own page with the AI tutor. Class 7 Science, CBSE 2026-27.

20 questions

1–5 marks · Medium difficulty

  1. 1

    Question 1

    Farida's little brother's toy car has stopped running, so Farida buys a new cell for it. The toy car's cell compartment has a "+" moulded at one end and a "–" at the other. The "+" and "–" signs printed on the new cell have worn off, as shown below.

    The toy car's cell compartment with a spring at the minus end, and a new cell with no signs on it

    Which end of the new cell should Farida place against the "+" end of the compartment?

    MCQMedium
    1 mark
  2. 2

    Question 2

    Arjun's new torch has a lamp that is fixed in it and cannot be taken out. Through the clear front cover he sees that there is no thin wire inside the lamp. In his science kit he finds a spare lamp of the same kind. It has two wires coming out of its base, and one wire is longer than the other.

    What kind of lamp is this, and how must it be connected to a battery to make it glow?

    MCQMedium
    1 mark
  3. 3

    Question 3

    Kavya makes the switch of Activity 3.8 with two drawing pins on a piece of cardboard. She has no safety pin, so she uses a paper clip that is covered with a layer of blue plastic. She joins her switch to a cell and a lamp as shown below. Even when the clip rests on both drawing pins, the lamp does not glow. The cell and the lamp both work in another circuit.

    A cardboard switch with a plastic-coated paper clip lying across two drawing pins, joined to a cell and a lamp

    What is the best reason why the lamp does not glow?

    MCQMedium
    1 mark
  4. 4

    Question 4

    For a class chart, four children each draw the circuit symbol for a battery made of two cells joined correctly. Their drawings are shown below.

    Four drawings P, Q, R and S of two cell symbols placed side by side

    Which drawing shows a battery of two cells joined correctly?

    MCQMedium
    1 mark
  5. 5

    Question 5

    Farhan tests a steel spoon with his conduction tester. The bowl of the spoon is bare steel, but its handle is covered with thick plastic. He touches the two free wires of the tester to the spoon at three different pairs of points, marked 1, 2 and 3 in the figure. Each time he makes sure the two wires do not touch each other.

    A spoon with a steel bowl and a plastic-covered handle; three pairs of points are marked 1, 2 and 3

    For which pair or pairs of points will the lamp of the tester glow?

    MCQMedium
    1 mark
  6. 6

    Question 6

    For Raksha Bandhan, Sana makes a greeting card for her brother. Inside the card she fixes a small LED and a button cell, so that one wire of the LED touches each flat face of the cell. The LED stays dark. She takes the cell out, turns it over, puts it back, and now the LED glows.

    Why did turning the cell over make the LED glow?

    MCQMedium
    1 mark
  7. 7

    Question 7

    Gauri lives in Shimla. For a school project she lists six electrical devices in her home: a geyser, a mixer grinder, a ceiling fan, a television, a water pump and a mobile phone.

    (i) Sort her six devices under the headings that Nihal's group used for the uses of electricity. (1 mark)

    (ii) Suggest one new heading of your own for grouping these devices. Place two of Gauri's devices under it and say why they belong there. (1 mark)

    Medium
    2 marks
  8. 8

    Question 8

    Pooja puts two new cells into her torch. When she slides the switch ON, the lamp does not glow. The figure shows how she placed the cells inside the torch.

    A torch opened up: cell 1 near the spring with its cap facing right, and cell 2 near the lamp with its cap facing left, so the two caps touch

    (i) What is wrong with the way Pooja has placed the cells? (1 mark)

    (ii) What should she do so that the torch works? (1 mark)

    Medium
    2 marks
  9. 9

    Question 9

    Tara builds a circuit with a cell, a lamp and her home-made drawing-pin switch. She connects the switch between the lamp and the negative terminal of the cell, as shown in her circuit diagram. The switch is drawn in its ON position.

    Circuit diagram: a cell at the top, a switch in the ON position on the right side next to the cell's short line, and a lamp at the bottom

    Her friend Raghav says, "Your lamp will never glow, because a switch must always be next to the positive terminal."

    (i) Will the lamp glow? Who is right, Tara or Raghav? (1 mark)

    (ii) Explain your answer using the idea of a complete path for the current. (1 mark)

    Medium
    2 marks
  10. 10

    Question 10

    Dadi asks the shopkeeper for "a battery" for her radio. He gives her two separate cells. Her grandson Kunal says, "These are two cells, not a battery."

    (i) When do these two cells become a battery? (1 mark)

    (ii) Kunal also says it is wrong to call the single cell inside his mobile phone a battery. Is he right? Give a reason. (1 mark)

    Medium
    2 marks
  11. 11

    Question 11

    At an electrical shop in Chandni Chowk, Aliya watches the shopkeeper cut a piece of the wire used in houses. Inside she sees shiny reddish-brown metal strands, and outside a coloured plastic covering. The shopkeeper says, "The metal is copper. Silver and gold are also among the best conductors of electricity."

    (i) Why is copper used for the wire, and not silver or gold? (1 mark)

    (ii) Why is the copper covered with plastic? (1 mark)

    Medium
    2 marks
  12. 12

    Question 12

    Vikram's night-lamp kit comes with a leaflet. The leaflet shows the circuit diagram below, with the switch ON.

    Circuit diagram: a two-cell battery at the top, an ON switch on the right, and an LED at the bottom whose triangle points to the left

    (i) Will the LED glow if Vikram builds the circuit exactly as drawn? (1 mark)

    (ii) Explain your answer using what the symbols in the diagram tell you. (1 mark)

    Medium
    2 marks
  13. 13

    Question 13

    Sumana compares the lamp from Nani's old torch with an LED from her science kit. Her own torch uses the same kind of LED. The figure shows the two lamps.

    Two lamps side by side: a small glass-bulb lamp with a thin coiled wire inside and a metal base, and an LED with two legs of unequal length

    (i) What is the thin wire inside the glass bulb of Nani's lamp called? Does the LED have one? (1 mark)

    (ii) How is this thin wire held in place, and which two parts of Nani's lamp are its two terminals? (1 mark)

    (iii) What happens to the thin wire when Nani's torch is switched ON? Why does the lamp not glow at all if this wire breaks? (1 mark)

    (iv) Sumana says, "Both lamps can be connected to the cells either way round." Is she right? Explain for each lamp, and say how she can tell the two wires of the LED apart. (2 marks)

    Medium
    5 marks
  14. 14

    Question 14

    For the school mela, Manav builds a steady-hand game. A bent bare metal wire is fixed between two wooden blocks. A metal ring on a handle goes around the bent wire. One end of the bent wire is joined to a cell, the cell to a lamp, and the lamp to the ring, as shown. A player must move the ring along the bent wire without touching it. If the ring touches the wire, the lamp glows.

    The steady-hand game: a bent bare wire between two wooden blocks, a metal ring on a taped handle around it, wired to a cell and a lamp

    (i) Draw the circuit diagram of the game using the symbols you have learnt. Show the ring and the bent wire together as a switch. (2 marks)

    (ii) Why does the lamp glow only when the ring touches the bent wire? (1 mark)

    (iii) The bent wire has no plastic covering at all, but the wires joining the cell and the lamp keep their plastic covering except at their ends. Why is each of these done? (1 mark)

    (iv) On the day of the mela, the lamp glows all the time, even when the ring is not touching the bent wire. The cell and the lamp are fine. Suggest one likely reason. (1 mark)

    Medium
    5 marks
  15. 15

    Question 15

    Nisha makes a conduction tester from a cell, a lamp and two wires with free ends. She first touches the two free ends together, and the lamp glows, so her tester is ready. Then she tests six things from her kitchen counter, shown in the photo. For each one she touches the two free ends to two places on the object, and she records her results in a table.

    A kitchen counter with a steel ladle, a wooden rolling pin, a white ceramic cup, a roll of aluminium foil, a plastic lunch box and a steel spoon

    ObjectMaterialLamp glows?
    LadleSteelYes
    Rolling pinWoodNo
    CupCeramicNo
    FoilAluminiumNo
    Lunch boxPlasticNo
    SpoonSteelYes

    (i) Which material in Nisha's table could be used to cover an electric wire? Give a reason. (1 mark)

    (ii) What do the objects that made the lamp glow have in common? (1 mark)

    (iii) Her brother says, "Your result for the foil must be wrong." Do you agree? Explain, and say how Nisha should test the foil again. (2 marks)

    Medium
    4 marks
  16. 16

    Question 16

    It is a heavy monsoon evening. Ritika has just come out of her bath, and her hands are still wet. She wants to switch on the room light, but the wall around the switchboard has become damp from the rain.

    A girl with wet hair and a towel looking at a switchboard on a damp wall beside a rainy window

    What should Ritika do?

    MCQMedium
    1 mark
  17. 17

    Question 17

    Rehan's TV remote holds two cells side by side. At one end of the compartment, a metal strip joins the two cells. The figure shows four ways in which the cells could be placed.

    Four layouts A to D of two cells side by side in a remote's compartment, with a metal strip at the right end

    In which layout do the two cells form a battery, so that the remote can work?

    MCQMedium
    1 mark
  18. 18

    Question 18

    Sohan draws a circuit diagram for a circuit made of one cell, a switch that is ON and an incandescent lamp. His teacher says that two of his symbols are wrong.

    Sohan's circuit diagram: a cell drawn as two equal lines, a switch in the ON position, and a lamp drawn as a plain circle

    (i) Which two symbols are wrong? Describe how each should be drawn. (1 mark)

    (ii) Why is it important to draw the correct symbols? Give two reasons. (1 mark)

    Medium
    2 marks
  19. 19

    Question 19

    Mihir uses his conduction tester so often that its cell keeps running down. He plans to run the tester from the wall socket in his room instead, "so that it never runs out".

    (i) Why must Mihir not do this, and what should he use instead? (1 mark)

    (ii) How is the electricity from a wall socket different from the electricity from a cell? (1 mark)

    Medium
    2 marks
  20. 20

    Question 20

    Mr Ramesh runs a small torch repair kiosk in Madurai. A customer brings a two-cell torch that does not glow when its switch is slid ON. The cells are placed correctly, cap to disc. Mr Ramesh checks the torch one part at a time and writes down what he finds. When the switch is slid ON, its metal strip is meant to press against a metal contact inside the torch.

    A small roadside repair kiosk where a shopkeeper holds an opened torch while two customers stand by

    StepWhat he checkedResult
    1The torch's two cells, joined in his tester with a lamp he knows is goodThe lamp glows
    2The torch's own lamp, joined to a cell he knows is goodThe lamp glows
    3The torch's switch, slid to ONIts metal strip is bent and does not reach the metal contact

    (i) In step 1, why did Mr Ramesh use a lamp that he knew was good? (1 mark)

    (ii) Which part of the torch is faulty? Use the table to explain how you know. (1 mark)

    (iii) Explain why the bent strip stops the torch from glowing even when the switch is ON, and what bending the strip back will do. (2 marks)

    Medium
    4 marks