Opening your dashboard
Class 12 Physics Chapter 12 Semiconductor Electronics, Devices And Circuits: Practice Questions
30 questions on Chapter 12, each worked through on its own page with the AI tutor. Class 12 Physics, CBSE 2026-27.
30 questions
1–5 marks · Medium difficulty
- 11 mark
Question 1
In -type germanium, the energy needed to set free the extra electron of a donor atom is about
- 21 mark
Question 2
The threshold (cut-in) voltages of a germanium diode and a silicon diode are respectively about
- 31 mark
Question 3
The thickness of the depletion region of a - junction is of the order of
- 41 mark
Question 4
Assertion (A): The space between the electrodes of a vacuum tube must be evacuated.
Reason (R): Electrons moving through air would lose their energy in collisions with air molecules.
- 51 mark
Question 5
Assertion (A): The electrical conductivity of a semiconductor increases on doping.
Reason (R): Doping always increases the number of electrons in the semiconductor.
- 63 marks
Question 6
Give three differences between an intrinsic semiconductor and an extrinsic semiconductor.
- 73 marks
Question 7
The graph of potential barrier across the junction of an unbiased diode is shown by curve A. Curves B and C are obtained after biasing the same diode in two different ways. Identify the type of biasing in B and in C, and justify your answer.

- 83 marks
Question 8
(a) Draw the symbol of a - junction diode and mark its and ends. What does the arrow in the symbol indicate?
(b) Why are metallic contacts provided at the ends of a diode?
(c) Draw a circuit showing the diode forward biased, and mark the direction of the current.
- 93 marks
Question 9
An unmarked diode has two terminals, 1 and 2. An ohmmeter (whose battery drives current out of its "+" lead) is connected across it both ways. With "+" on terminal 1 it reads about 50 Ω; with "+" on terminal 2 it reads more than 10 MΩ.
(a) Which terminal is the -side? Explain.
(b) Why are the two readings so different?
(c) What would readings of about 50 Ω both ways tell you about the diode?
- 103 marks
Question 10
Before solid-state semiconductor devices were developed, electronic circuits used vacuum tubes (valves). Give three ways in which semiconductor devices are better than vacuum tubes, and explain why vacuum tubes are called valves.
- 115 marks
Question 11
Read the passage and answer the questions that follow.
Two samples are cut from the same pure silicon crystal, which has atoms per m³. Sample 1 is doped with phosphorus (5 valence electrons) and sample 2 with boron (3 valence electrons), each at a concentration of 5 parts per million. The figure shows a small part of each lattice; the circles are the atomic cores with their charge, and the small dots are the valence electrons in the bonds.

(a) How many silicon atoms are there for every dopant atom, and what is the number of dopant atoms per m³? (2 marks)
(b) Using the figure, explain what happens to the fifth valence electron of the phosphorus atom, and to the incomplete fourth bond of the boron atom, at room temperature. (2 marks)
(c) What is the net charge of the phosphorus atom after it has lost its fifth electron, and of the boron atom after it has taken an electron to complete its fourth bond? (1 mark)
- 125 marks
Question 12
A diode D is connected in series with a 2.2 kΩ resistor across a 9 V battery, as shown.

(a) Find the current if D is a silicon diode with a forward drop of 0.7 V.
(b) What is the current if the same diode is connected the other way round? Where does the 9 V appear then?
(c) Find the current if D is treated as an ideal diode, and the percentage error this simplification causes.
(d) Find the power supplied by the battery in (a) and how it is shared between the resistor and the diode.
- 135 marks
Question 13
Read the following passage and answer the questions that follow.
Each atom of Ge and Si is surrounded by four nearest neighbours in a diamond-like lattice. Every atom shares one of its four valence electrons with each of its four neighbours, and takes a share of one electron from each of them, forming covalent (valence) bonds. The figure is a two-dimensional picture of this structure at low temperature, with all bonds intact. As the temperature increases, some bonds break, producing electron-hole pairs. In an intrinsic semiconductor the free-electron concentration equals the hole concentration , and both are equal to the intrinsic carrier concentration .

(A) What is the name of the lattice structure of Si and Ge?
(B) What type of bonds do Si and Ge atoms form?
(C) How does an intrinsic semiconductor behave at 0 K?
(D) What is the relation between the electron and hole concentrations in an intrinsic semiconductor?
(E) Carbon also has four valence electrons and the same lattice structure as Si and Ge. Why is carbon an insulator while Si and Ge are intrinsic semiconductors?
- 141 mark
Question 14
Silicon has a diamond-like lattice whose cubic unit cell has side Å and contains 8 atoms. The number of silicon atoms per m³ is about
- 151 mark
Question 15
The intrinsic carrier concentration of germanium at room temperature is . A piece of pure germanium has a volume of 1 mm³. The numbers of free electrons and holes in it are
- 161 mark
Question 16
In the circuit shown, D is a silicon diode with a forward drop of 0.7 V. The current drawn from the 10 V battery is

- 171 mark
Question 17
A half-wave rectifier is fed with 50 Hz ac. For how long does the diode conduct in each cycle of the input?
- 182 marks
Question 18
Apart from a capacitor across the load, an inductor connected in series with the load can also be used to smooth the output of a rectifier. Explain how the inductor helps.
- 193 marks
Question 19
(a) In an isolated atom the electron energies are fixed by its orbits. Explain why, in a crystal, these energies spread into bands.
(b) One cubic centimetre of silicon contains about atoms. Its valence band holds states and is about 4 eV wide. Estimate the average spacing between neighbouring levels in the band, and explain why the band can be treated as continuous.
- 201 mark
Question 20
An ideal diode and a capacitor are connected in series to an ac source of peak voltage 10 V. There is no load across the capacitor. After the first few cycles, the voltage across the capacitor is
- 211 mark
Question 21
Copper has about free electrons per m³. Pure silicon at room temperature has about free electrons per m³. The number of free electrons per m³ in copper is larger by a factor of about
- 223 marks
Question 22
A bulb rated 60 W, 230 V is connected to the 230 V, 50 Hz mains through an ideal diode, as shown. Treat the bulb's resistance as constant.

(a) Find the resistance of the bulb and the peak current through it.
(b) Find the average power consumed by the bulb now.
(c) How often does the bulb receive a pulse of current, and why may it show a slight flicker?
- 232 marks
Question 23
Silicon diodes are generally preferred to germanium diodes in circuits that become warm during use. Explain why, in terms of the energy gaps of the two materials.
- 242 marks
Question 24
In a centre-tap full-wave rectifier the output is taken between the common point X of the two diodes and the centre tap Y. If both diodes are connected the other way round, what happens to the output? Sketch the output waveform.
- 251 mark
Question 25
Two statements are given below. One is labelled Assertion (A) and the other is labelled Reason (R). Read the statements carefully and choose the option that correctly describes statements A and R.
Assertion (A): Under reverse bias, the depletion region of a - junction becomes wider.
Reason (R): Reverse bias pushes the majority carriers on both sides towards the junction.
- 262 marks
Question 26
When a - junction is forward biased, the applied voltage appears almost entirely across the depletion region, and the voltage drop across the -side and the -side is negligible. Explain why.
- 273 marks
Question 27
A silicon device needs the hole concentration in an -type region to be no more than at 300 K, where . Silicon has atoms per m³.
(a) Find the donor concentration needed (all donors ionised).
(b) Express this as parts per million of silicon atoms, and name a suitable dopant.
(c) Why is it justified to take the electron concentration equal to the donor concentration?
- 281 mark
Question 28
Two statements are given below. One is labelled Assertion (A) and the other is labelled Reason (R). Read the statements carefully and choose the option that correctly describes statements A and R.
Assertion (A): Below breakdown, the reverse current of a - junction diode increases in proportion to the reverse voltage.
Reason (R): The reverse current is carried by majority carriers crossing the junction.
- 295 marks
Question 29
Read the passage and answer the questions that follow.
A student measures the characteristic of a germanium diode. The forward readings, (0.10 V, 0.5 mA), (0.20 V, 3 mA), (0.24 V, 8 mA) and (0.30 V, 38 mA), are plotted in the graph below. In reverse bias, at −10 V, the current is 12 µA.

(a) Estimate the threshold voltage of this diode.
(b) Find its dynamic resistance between 0.24 V and 0.30 V.
(c) Find its static resistance at 0.30 V.
(d) Find its resistance in reverse bias at −10 V.
(e) Using your value of , estimate the forward voltage at which the current is 23 mA.
- 305 marks
Question 30
Read the passage and answer the questions that follow.
A germanium crystal contains atoms per m³, and its intrinsic carrier concentration at room temperature is . It is doped with indium at a concentration of 1 indium atom for every germanium atoms. Assume every indium atom is ionised.
(a) What type of semiconductor is formed? (1 mark)
(b) Find the concentration of indium atoms. (1 mark)
(c) Taking the hole concentration as equal to the indium concentration, find the electron concentration. (1 mark)
(d) Find the ratio of the numbers of majority and minority carriers. (1 mark)
(e) Is it reasonable to take the hole concentration equal to the indium concentration here? Give a reason. (1 mark)
