In a tensile test of a ductile metal, the stress is calculated as the applied force divided by the original cross-sectional area of the specimen. Beyond the ultimate point D, the recorded stress falls while the strain keeps growing, until the specimen breaks at E. Why does this happen? And why is the ultimate tensile strength quoted at D, not at the fracture point E?
Competency-Based Questions (CBQ) · Question 40 of 80
In a tensile test of a ductile metal, the stress is calculated as the applied force divided by the original…
Question 402 marksMedium
Beyond D, the specimen begins to thin sharply at one place (it "necks"). The area carrying the load there becomes smaller and smaller, so additional strain is produced even by a reduced applied force. Since the recorded stress is , with the original area, a smaller force gives a smaller recorded stress, even as the specimen goes on stretching until it breaks at E.
The ultimate tensile strength is quoted at D because D corresponds to the greatest load the specimen can bear. Once D is passed, the specimen can no longer support that load and goes on to fracture, so in design the stress at D, not the lower recorded stress at E, marks the limit of strength.
