Competency-Based Questions (CBQ) · Question 23 of 80
Read the passage and answer the questions that follow.
Question 235 marksMedium
Read the passage and answer the questions that follow.
The cabin of a passenger lift has a mass of 1200 kg including its full load. It hangs from a steel cable that passes over a pulley at the top of the shaft to the motor. When the lift starts upwards, its acceleration can be as large as 1.5m s−2. The engineer uses steel with yield strength 250×106N m−2 and Young's modulus 2.0×1011N m−2 (Table 8.1), with a safety factor of 5 on the largest tension. When the cabin is at the ground floor, 50 m of cable hangs between the pulley and the cabin. Take g=9.8m s−2 and neglect the mass of the cable.
(i) Find the largest tension in the cable.
(ii) Find the minimum cross-sectional area of the cable, and the diameter of a single solid cable with this area.
(iii) The cable is actually made by twisting together steel wires, each of diameter 1.0 mm. How many wires are needed at least?
(iv) The cable has exactly the area found in (ii). By how much does the 50 m length stretch when the tension is at its largest value?
(v) The empty cabin (mass 640 kg) is at rest at the ground floor, level with the floor of the lobby. Eight passengers of total mass 560 kg step in. By how much does the cabin sink below the lobby floor?
(i) The tension is largest when the cabin accelerates upwards. Taking upwards as positive, Newton's second law for the cabin gives
T−mg=ma⇒T=m(g+a)=1200×(9.8+1.5)=1200×11.3=13560N
Tmax=13560N≈1.36×104N. This is 15% more than the tension when the cabin hangs at rest (1200×9.8=11760N).
(ii) With a safety factor of 5, the cable must be able to carry 5Tmax without reaching its yield strength:
A≥σy5Tmax=250×1065×13560=2.71×10−4m2
For a single solid cable of diameter D, A=4πD2:
D=π4A=π4×2.71×10−4=1.86×10−2m
A=2.71×10−4m2, equivalent to a solid cable of diameter 1.86cm.
The number must be a whole number and must not give less than the required area, so at least 346 wires are needed.
(iv) At the largest tension the stress in the cable is
σ=ATmax=2.71×10−413560=5.0×107N m−2
(one-fifth of the yield strength, as the safety factor requires).
ΔL=YσL=2.0×10115.0×107×50=1.25×10−2m
The 50 m of cable stretches by 12.5mm.
(v) The extra load is the weight of the passengers, 560×9.8=5488N. The cable behaves like a spring, so the extra stretch is
ΔL=AYFL=2.71×10−4×2.0×10115488×50=5.06×10−3m
The cabin sinks about 5.1mm below the lobby floor. Though small, a step of this size can trip a passenger, which is why lifts with long cables have a levelling system that raises the cabin back to the floor level after heavy loading. With a shorter length of cable (at a higher floor), the sinking would be proportionally smaller.