Competency-Based Questions (CBQ) · Question 30 of 80
A punch press uses a flywheel to punch holes in steel sheet.
Question 303 marksMedium
A punch press uses a flywheel to punch holes in steel sheet. The flywheel is a uniform disc of mass 50 kg and radius 0.4 m, turning at 240 rpm about its axis. Each punch takes 400 J of energy from the flywheel in a fraction of a second, too quickly for the motor to replace it during the punch.
(a) Find the moment of inertia and the kinetic energy of the flywheel before a punch.
(b) Find the angular speed of the flywheel just after a punch, in rad s⁻¹ and in rpm.
(c) Explain why the press uses a heavy flywheel rather than driving the punch directly from the motor.
Just after a punch, ω′=20.8rad s−1=198rpm, a drop of about 17%.
(c) The punch needs a large amount of energy (400 J) in a very short time, i.e. a very large power, which a small motor cannot supply. A flywheel with a large moment of inertia stores a lot of rotational kinetic energy and can give up 400 J with only a modest fall in speed. Between punches, the motor supplies energy at a small, steady rate and brings the flywheel back to 240 rpm. The large I also resists sudden changes of speed, so the machine runs smoothly.