Confirming your payment

Skip to content

Opening your dashboard

Class 12 Physics Chapter 3 Current Electricity: Practice Questions

30 questions on Chapter 3, each worked through on its own page with the AI tutor. Class 12 Physics, CBSE 2026-27.

30 questions

1–5 marks · Medium difficulty

  1. 1

    Question 1

    In an electrolyte, 3×10183 \times 10^{18} positive ions (each of charge +e+e) move to the right, and 2×10182 \times 10^{18} electrons move to the left, through a cross-section every second. The current is

    MCQMedium
    1 mark
  2. 2

    Question 2

    The potential difference across the terminals of a cell is 2.2 V when no current is drawn, and 1.8 V when a 4 Ω4\ \Omega resistor is connected across it. The internal resistance of the cell is about

    MCQMedium
    1 mark
  3. 3

    Question 3

    The resistivity of a metal wire depends on

    MCQMedium
    1 mark
  4. 4

    Question 4

    Assertion (A): The figure shows a Wheatstone bridge that is not balanced.

    Class 12 Physics Current Electricity

    Reason (R): For a balanced bridge, no current should flow through the galvanometer.

    MCQMedium
    1 mark
  5. 5

    Question 5

    Assertion (A): In the network shown, the equivalent resistance between A and B is 2R2R.

    Class 12 Physics Current Electricity

    Reason (R): All the resistors are connected in parallel between A and B.

    MCQMedium
    1 mark
  6. 6

    Question 6

    The potential difference applied across a given conductor is doubled. How will this affect

    (A) the mobility of the electrons, and

    (B) the current density in the conductor?

    Justify your answers.

    Medium
    3 marks
  7. 7

    Question 7

    Two copper wires, P and Q, of the same area of cross-section are joined in parallel. The combination is connected across a battery of potential difference VV. If the lengths of the wires P and Q are in the ratio 1:21 : 2, find the ratio of the drift velocities of electrons in P and Q.

    Medium
    3 marks
  8. 8

    Question 8

    A cell of emf 3 V and internal resistance 4 Ω4\ \Omega is connected to two resistors of 10 Ω10\ \Omega and 24 Ω24\ \Omega joined in parallel. Using Kirchhoff's laws, find the current through each resistor and the total current in the circuit.

    Medium
    3 marks
  9. 9

    Question 9

    The resistances in the four arms of a Wheatstone bridge are 30 Ω30\ \Omega, 60 Ω60\ \Omega, 15 Ω15\ \Omega, and a series combination of 5 Ω5\ \Omega and X ΩX\ \Omega (in that order). If the bridge is balanced, find XX.

    Medium
    3 marks
  10. 10

    Question 10

    The resistance of the platinum wire of a platinum resistance thermometer is 5 Ω5\ \Omega at the ice point and 5.23 Ω5.23\ \Omega at the steam point. When the thermometer is inserted in a hot bath, the resistance of the wire is 5.795 Ω5.795\ \Omega. Calculate the temperature of the bath.

    Medium
    3 marks
  11. 11

    Question 11

    (A) Define relaxation time. Show that the resistivity of a conductor is ρ=mne2τ\rho = \dfrac{m}{ne^2\tau}.

    (B) Aluminium has about 1.8×10291.8 \times 10^{29} free electrons per cubic metre (three per atom) and a resistivity of 2.7×10−8 Ω2.7 \times 10^{-8}\ \Omega m. Find the relaxation time of its electrons. (m=9.1×10−31m = 9.1 \times 10^{-31} kg, e=1.6×10−19e = 1.6 \times 10^{-19} C)

    (C) Why does the resistivity of a metal increase with temperature?

    Medium
    5 marks
  12. 12

    Question 12

    (A) Show that the balance condition of a Wheatstone bridge does not depend on the emf of the battery or the resistance of the galvanometer.

    (B) In a Wheatstone bridge, P=4 ΩP = 4\ \Omega, Q=8 ΩQ = 8\ \Omega and R=6 ΩR = 6\ \Omega. Find the value of SS for balance.

    (C) With the bridge balanced and an ideal 6 V battery connected, find the current in each arm, and show that the two ends of the galvanometer are at the same potential.

    Medium
    5 marks
  13. 13

    Question 13

    Read the following text and answer any four of the questions that follow.

    Electric toaster: The Small Industries Service Institute, Takyelpat Industrial Estate, Imphal, has designed an electric toaster that operates on 220 V a.c., single phase, and is available in four rated capacities: 600 W, 750 W, 1000 W and 1250 W. The heating element is made of nichrome 80/20 (80% nickel, 20% chromium), since nichrome does not oxidise readily at high temperature and has a high resistivity, so a short, compact element provides the resistance needed. The element is wound separately on mica sheets and fitted to the body of the toaster with ceramic terminals.

    (A) What is the heating element of the toaster made of?

    (B) What is meant by nichrome 80/20?

    (C) Which model will consume the most electricity in the same time?

    (D) What is the operating voltage of the device?

    (E) Name the insulating materials used in the device.

    Medium
    5 marks
  14. 14

    Question 14

    A current of 4 A flows through a wire of cross-sectional area 2 mm22\ \text{mm}^2. The current density in the wire is

    MCQMedium
    1 mark
  15. 15

    Question 15

    A piece of germanium (a semiconductor) and a copper wire are both heated from room temperature to 80∘80^\circC. Their resistances respectively

    MCQMedium
    1 mark
  16. 16

    Question 16

    A uniform wire of resistance 12 Ω12\ \Omega is bent into the shape of an equilateral triangle. The resistance between any two corners of the triangle is

    MCQMedium
    1 mark
  17. 17

    Question 17

    An electric heater is rated 1000 W at 220 V. If the supply voltage drops to 200 V, the power of the heater (assuming its resistance stays the same) becomes about

    MCQMedium
    1 mark
  18. 18

    Question 18

    The terminal voltage VV of a cell varies with the current II drawn from it as shown. The short-circuit current of the cell is

    Class 12 Physics Current Electricity

    MCQMedium
    1 mark
  19. 19

    Question 19

    Assertion (A): A semiconductor diode does not obey Ohm's law.

    Reason (R): The VV–II graph of a diode is not a straight line, and the current for a given voltage depends on the sign (polarity) of the voltage.

    MCQMedium
    1 mark
  20. 20

    Question 20

    Assertion (A): When identical cells are connected in parallel, the emf of the combination is equal to the emf of one cell.

    Reason (R): The internal resistance of the parallel combination is smaller than the internal resistance of one cell.

    MCQMedium
    1 mark
  21. 21

    Question 21

    Assertion (A): A fuse wire is made of a material of fairly high resistivity and low melting point.

    Reason (R): A fuse is connected in parallel with the appliance it protects.

    MCQMedium
    1 mark
  22. 22

    Question 22

    A copper wire is 1.0 m long and has a radius of 0.50 mm. The resistivity of copper is 1.7×10−8 Ω1.7 \times 10^{-8}\ \Omega m. Find its resistance. What would its resistance be if the same wire were drawn out to twice its length?

    Medium
    2 marks
  23. 23

    Question 23

    An electric kettle rated 2.0 kW is used to heat 1.5 kg of water from 20∘20^\circC to 100∘100^\circC. Only 80% of the electrical energy goes into the water. How long does it take? (Specific heat capacity of water = 4200 J kg−1 ∘C−14200\ \text{J kg}^{-1}\ ^\circ\text{C}^{-1}.) What is the cost of this at ₹8 per kWh?

    Medium
    3 marks
  24. 24

    Question 24

    A 12 V battery of internal resistance 1 Ω1\ \Omega and a 6 V battery of internal resistance 2 Ω2\ \Omega are connected in series with a 3 Ω3\ \Omega resistor, with their emfs opposing each other (positive terminal joined to positive terminal). Find the current, and the terminal potential difference of each battery. Which battery is being charged?

    Medium
    3 marks
  25. 25

    Question 25

    An aluminium wire of cross-sectional area 1.0 mm21.0\ \text{mm}^2 carries a current of 2.0 A. The drift speed of the electrons is measured to be 0.20 mm/s. Find

    (a) the number of free electrons per cubic metre of aluminium, and

    (b) the number of free electrons in a 1 m length of the wire.

    Medium
    3 marks
  26. 26

    Question 26

    Two cells of emfs E1E_1 and E2E_2 and internal resistances r1r_1 and r2r_2 are connected in series, the negative terminal of the first joined to the positive terminal of the second. Derive the emf and internal resistance of the equivalent single cell. Hence write the result for nn identical cells in series, and for the case when the second cell is reversed.

    Medium
    3 marks
  27. 27

    Question 27

    A bird can sit safely on a single overhead power line carrying a large current at 11 kV. Explain why. Why would it be in danger if it touched two different wires at once?

    Medium
    2 marks
  28. 28

    Question 28

    Match each quantity in Column I with its SI unit in Column II.

    Column IColumn II
    (a) Resistivity(i) m2 V−1 s−1\text{m}^2\,\text{V}^{-1}\,\text{s}^{-1}
    (b) Conductivity(ii) A m−2\text{A}\,\text{m}^{-2}
    (c) Mobility(iii) Ω m\Omega\,\text{m}
    (d) Current density(iv) S m−1\text{S}\,\text{m}^{-1} (siemens per metre)
    Medium
    2 marks
  29. 29

    Question 29

    The phone battery. A smartphone battery is rated 3.8 V, 4000 mAh. The rating in milliampere-hours tells how much charge the battery can deliver: 4000 mA for one hour, 2000 mA for two hours, and so on. Its internal resistance is about 0.15 Ω0.15\ \Omega. In normal use the phone draws about 0.5 A; a fast charger pushes 2.0 A into the battery.

    Class 12 Physics Current Electricity

    (i) How much charge, in coulombs, can the fully charged battery deliver?

    (ii) How much energy does it store, in joules and in watt-hours?

    (iii) For how long can it run the phone in normal use?

    (iv) Find the terminal voltage of the battery (a) in normal use, and (b) while it is being fast-charged.

    Medium
    4 marks
  30. 30

    Question 30

    The graph shows how the resistivity of three materials, P, Q and R, varies with temperature.

    Class 12 Physics Current Electricity

    (a) Identify which curve belongs to (i) copper, (ii) nichrome, (iii) silicon. Give a reason for each.

    (b) Which material would you choose for a standard resistor, and which for the element of a thermometer that must be very sensitive at room temperature?

    Medium
    3 marks