A student wants to measure the current through a resistor and the potential difference across it at the same time. The correct way to connect the two meters is:
Practice Questions · Question 27 of 30
A student wants to measure the current through a resistor and the potential difference across it at the same time.
(A) both the ammeter and the voltmeter in series with the resistor
(B) both the ammeter and the voltmeter in parallel with the resistor
- Correct answer
(C) the ammeter in series and the voltmeter in parallel with the resistor
(D) the ammeter in parallel and the voltmeter in series with the resistor
Option (C) is correct.
Explanation:
An ammeter measures the current through the resistor, so the same current must pass through the meter too — that means connecting it in series. Its resistance is made very low so that inserting it barely changes the current it is there to measure.
A voltmeter measures the potential difference across the resistor, so it must be connected between the same two points as the resistor — that is, in parallel. Its resistance is made very high so that it draws almost no current.
(A) is wrong: a voltmeter in series adds its very large resistance to the circuit, so the current falls almost to zero. The ammeter then reads practically nothing, and the voltmeter reads almost the whole cell voltage instead of the p.d. across the resistor.
(B) is the dangerous one: a low-resistance ammeter placed in parallel short-circuits the resistor. The current is then limited only by the cell, so it becomes very large and the ammeter is likely to be damaged.
(D) is wrong on both counts, but it is not the dangerous one: the voltmeter in series chokes the current down to almost zero, so the ammeter — although wrongly placed in parallel — carries almost no current and reads nearly zero, while the voltmeter again reads almost the full cell voltage.
