Suppose Sumana forgets to move the switch of her lifting electromagnet model to OFF position (in introduction story). After some time, the iron nail no longer picks up the iron paper clips, but the wire wrapped around the iron nail is still warm. Why did the lifting electromagnet stop lifting the clips? Give possible reasons.
Electricity: Magnetic and Heating Effects · Question 8 of 11
Suppose Sumana forgets to move the switch of her lifting electromagnet model to OFF position (in introduction story).
The nail lifts the clips only while enough electric current flows through the coil. Possible reasons why it stopped:
1. The battery got used up. With the switch left ON, current flowed for a long time. Over time the chemicals inside the cells got used up, so the battery stopped supplying current (it became "dead"). With no current, the coil lost its magnetic effect and the clips were no longer attracted. The book warns that keeping a coil connected to a cell for more than a few seconds makes the cell weaken quickly.
2. The current became too small. Even before the battery is fully dead, a weakened battery gives a smaller current. A smaller current makes a weaker electromagnet, which may be too weak to lift the clips.
3. A connection came loose. If a wire came off the battery or the switch, the circuit would break and the current would stop.
Why is the wire still warm? While the current flowed for a long time, the heating effect of electric current warmed the wire. When the current stops, the magnetic effect disappears at once, but the warm wire takes some time to cool down. So the wire can still be warm even though the nail no longer lifts the clips.
