Explain the following:
(a) Why is the tungsten used almost exclusively for filament of electric lamps?
(b) Why are the conductors of electric heating devices, such as bread-toasters and electric irons, made of an alloy rather than a pure metal?
(c) Why is the series arrangement not used for domestic circuits?
(d) How does the resistance of a wire vary with its area of cross-section?
(e) Why are copper and aluminium wires usually employed for electricity transmission?
Electricity · Question 18 of 18
Explain the following
(a) Tungsten is used for lamp filaments mainly because of its very high melting point (). A filament must become white hot to give out light, and tungsten can stay at that temperature without melting. Its resistivity is also higher than that of the copper connecting wires; since the filament and the wires carry the same current, most of the heat () is produced in the thin tungsten coil. The bulb is filled with a chemically inactive gas such as nitrogen or argon to make the filament last longer.
(b) Electric heating devices use alloys for their conductors because alloys have higher resistivity compared to pure metals. This means they produce more heat when electricity flows through them, which is necessary for heating appliances like toasters and irons. They also do not oxidise (burn) readily at high temperatures, unlike pure metals, which makes them more durable for repeated heating.
The two reasons, side by side:
| Property of the alloy (e.g. nichrome) | Why it matters in a heater |
|---|---|
| Higher resistivity than a pure metal | More heat () is produced for the same current |
| Does not oxidise (burn) readily at high temperatures | The element survives repeated heating |
(c) Series arrangements are not used in domestic circuits because:
- Voltage is divided among all devices, so each device gets less than its required voltage.
- If one device fails, the entire circuit stops working.
- The total resistance increases, reducing the current flowing through the circuit.
- The same current flows through every device, but different appliances need different currents (a heater needs far more than a bulb).
- Devices cannot be switched on and off independently.
In a parallel arrangement, every appliance gets the full mains voltage, draws the current it needs, and has its own switch, so one failing does not affect the others.

(d) Resistance is inversely proportional to the wire's cross-sectional area, since . This means that as the cross-sectional area increases, the resistance decreases, and vice versa. A thicker wire has less resistance than a thinner one.
(e) Copper and aluminium are used for electricity transmission because they are excellent conductors with low resistivity. This results in less power loss as heat and makes them efficient for carrying electricity over long distances.
