A half-wave rectifier is connected directly to the 230 V (rms), 50 Hz mains, with no transformer. A large capacitor is connected across its load, so the output stays close to the peak mains voltage. The largest reverse voltage across the diode, and the reason, are
Competency-Based Questions (CBQ) · Question 66 of 80
A half-wave rectifier is connected directly to the 230 V (rms), 50 Hz mains, with no transformer.
- Correct answer
(A) about 650 V, because the capacitor holds the cathode at about +325 V while the anode swings to −325 V
(B) about 325 V, because only the peak mains voltage can appear across the diode
(C) 230 V, because the rms value is the effective voltage the diode experiences
(D) about 460 V, because the diode must withstand twice the rms value
Option (A) is correct.
Explanation: The peak mains voltage is
The large capacitor charges to about and holds the diode's cathode (joined to the load) near V, since it discharges only slightly between pulses. In the negative half-cycle the diode's anode, joined to the mains, swings down to V. The reverse voltage across the diode is then
So the diode needs a reverse breakdown voltage well above 650 V.
- (B) is the answer without the capacitor, when no current flows in the negative half and the load, hence the cathode, is at 0 V. With the capacitor the cathode stays charged.
- (C) uses the rms value; the diode breaks down at the instantaneous voltage.
- (D) doubles the rms value; the instantaneous voltages that add are the peaks, V, not V.
