Confirming your payment

Skip to content

Competency-Based Questions (CBQ) · Question 27 of 80

A model wing of area 0.12 m² is tested in a wind tunnel.

Question 274 marksMedium

A model wing of area 0.12 m20.12\ \text{m}^2 is tested in a wind tunnel. Small holes (pressure taps) in its upper and lower surfaces are connected by tubes to the two arms of a U-tube containing water, as shown in the figure. With the air flowing, the water levels in the two arms differ by 2.0 cm. The air flows past the lower surface at 30 m s−130\ \text{m s}^{-1} relative to the wing. Take the density of air 1.2 kg m−31.2\ \text{kg m}^{-3}, the density of water 1000 kg m−31000\ \text{kg m}^{-3} and g=9.8 m s−2g = 9.8\ \text{m s}^{-2}. Treat the air as an ideal fluid and assume the pressure difference is the same over the whole wing.

Class 11 Physics Mechanical Properties Of Fluids Question 27

(a) Find the pressure difference between the lower and upper surfaces, and the lift on the model wing.

(b) Find the speed of the air over the upper surface.

(c) By what percentage is the air over the wing faster than the air under it? What is it about the wing that produces this difference?