Option (B) is correct.
Explanation: A soap film has two surfaces, so the excess pressure inside a bubble of radius r is 4S/r. With Pa outside:
P1=Pa+r14S,P2=Pa+r24S
The smaller bubble (r1=3.0 cm) has the higher pressure. The common film has the smaller bubble on one side and the larger on the other, so the pressure difference across it must equal 4S/R:
R4S=r14S−r24S⇒R1=3.01−4.01=121⇒R=12 cm
The pressure is greater on the concave side of a curved surface. The higher pressure is in the smaller bubble, so the film is concave towards the smaller bubble, that is, it bulges into the larger bubble.
(A) is wrong: the radius is right, but a film bulging into the smaller bubble would be concave towards the larger bubble, which has the lower pressure.
(C) is wrong: 1.0 cm is just the difference of the radii; the curvatures (1/r), not the radii, subtract.
(D) is wrong: 1.7 cm comes from adding the curvatures, 3.01+4.01; the film is pressed by the smaller bubble and pushed back by the larger, so the excess pressures subtract.