(a)
steel: 400250=0.63,copper: 400200=0.50,aluminium: 11095=0.86
The ratios are 0.63 (steel), 0.50 (copper) and 0.86 (aluminium).
(b) A part first shows a permanent set when the stress reaches the yield strength σy, and it breaks when the stress reaches σu. The ratio σy/σu tells us how close these two stresses are. For aluminium, yielding begins at 86% of the breaking stress, so an overload only about 16% larger than the one that first bends it permanently (110/95=1.16) will break it. Aluminium gives the least warning: soon after it starts to deform permanently, it can fail.
(c) Copper, with the smallest ratio (0.50): it begins to deform permanently at only half its breaking stress, so the load must double after the first visible bending before it can snap. Steel (0.63) also gives a good margin and is much stronger, so it would be chosen where strength matters as well; aluminium gives the smallest margin.