Competency-Based Questions (CBQ) · Question 34 of 80
A carpenter holds an electric drill and looks along it from behind, towards the wall being drilled.
Question 342 marksMedium
A carpenter holds an electric drill and looks along it from behind, towards the wall being drilled. The drill bit turns clockwise as seen by the carpenter.
(a) In which direction does the angular velocity vector of the bit point? When the drill is switched off and the bit slows down, in which direction does its angular acceleration point?
(b) The bit turns at 3000 rpm and has a radius of 4 mm. Take the x-axis forward along the bit into the wall, the z-axis vertically up and the y-axis to the carpenter's left. Find the angular speed of the bit and, using v=ω×r, the velocity (magnitude and direction) of the point on the cutting edge directly above the axis.
(a) The angular velocity vector lies along the axis of rotation, in the direction given by the right-hand rule: curl the fingers of the right hand in the sense of rotation, and the thumb gives the direction of ω. Rotation that looks clockwise to the observer gives a vector pointing away from the observer. So ω points forward, along the bit into the wall.
After switch-off, ω decreases while its direction stays the same. Since α=dtdω and ω is getting shorter, α points backward, towards the carpenter, opposite to ω.
(b)
ω=603000×2π=100π=314rad s−1
From (a), ω points forward: ω=314i^rad s−1. The point directly above the axis is at r=0.004k^m from the axis:
v=ω×r=314i^×0.004k^=1.26(i^×k^)=−1.26j^m s−1
ω=314rad s−1; the top of the cutting edge moves at 1.26m s−1 in the −y direction, i.e. to the carpenter's right. This agrees with (a): for rotation that looks clockwise to the carpenter, the top of the bit moves from left to right.