(a) Dichloromethane (313 K) and Q (384 K) have boiling points far apart and far below anything at which P would vaporise, so simple distillation at atmospheric pressure is enough. Dichloromethane distils first at about 313 K; the receiver is changed and Q distils at about 384 K. The solid P and the tar are non-volatile at these temperatures and remain in the flask as a residue.
(b) The residue is dissolved in the minimum volume of hot ethanol, giving a nearly saturated solution. A little activated charcoal is added and the solution is boiled briefly; the charcoal adsorbs the coloured impurities. The hot solution is filtered quickly to remove the charcoal (and any insoluble matter). On cooling, the solubility of P falls sharply and it crystallises out. The crystals are collected by filtration, washed with a small amount of cold ethanol (in which P is only slightly soluble) and dried. The coloured material either stays on the charcoal or remains dissolved in the cold mother liquor, which is filtered away from the crystals.
(c) All distances are measured from the baseline; solvent front = 7.5 cm.
Rf (lower spot)=7.52.1=0.28Rf (upper spot)=7.54.8=0.64
The authentic sample in lane 2 gives a single spot at 4.8 cm, so the spot with Rf = 0.64 is P. The spot with Rf = 0.28 is an impurity that has crystallised along with P, so one crystallisation was not enough. The chemist should recrystallise P from fresh hot ethanol, repeating until TLC shows only the spot at Rf 0.64. A sharp melting point at 460 K then confirms that P is pure.