(a)
I=VP=2202000=9.1 A
(b) The joint is in series with the heater, so the same current passes through it:
Pjoint=I2R=(9.1)2×0.5=82.81×0.5=41.4≈41 W
(Strictly, adding the 0.5 Ω to the heater's own 24.2 Ω lowers the current a little, to 8.9 A, giving about 40 W. The difference is small because 0.5 Ω is small beside 24.2 Ω, so the rated current is a good enough value to work with.)
(c) The two things being compared are power, and they are not what decides whether something melts. What matters is how much power is released per unit of area, and whether it can escape.
| Heater element | The loose joint |
|---|
| Power released | 2000 W | 41 W |
| Released over | a long coil, tens of centimetres | a contact the size of a match head |
| Heat can escape by | air convection all around it, by design | almost nothing — buried in plastic |
| Result | glows at a safe designed temperature | plastic chars and melts |
The heater is built to get rid of 2000 W: the element is long, exposed, and air moves freely past it, so it settles at its designed working temperature — and it is made of nichrome, an alloy with a very high melting point that does not oxidise readily even when red-hot. The joint is a tiny patch of metal clamped inside a plastic housing, with no airflow at all. Its 41 W has nowhere to go, so the joint keeps heating until it reaches a few hundred degrees Celsius — not as hot as the glowing element, but far above the temperature at which the plastic around it softens and chars.
H=I2Rttells you where the heat is made; the surroundings decide where it goes.
And notice why a loose connection is so treacherous. The extra resistance is far too small to blow the fuse — the circuit still draws an almost normal current, and everything appears to work. The fault announces itself only by the smell of hot plastic.
(d) Stop using the socket and switch off the supply at the distribution board. The loose terminal must be tightened, or the socket replaced if it is damaged, by a qualified electrician before the circuit is used again. Scorched plastic should be replaced rather than reused, because it has already been degraded by the heat.