Concept used — the polymerase chain reaction (PCR)
PCR makes multiple copies of a gene (or DNA) of interest in vitro, using two sets of primers, deoxynucleotides and a thermostable DNA polymerase. Each cycle has three steps: denaturation (heat separates the two strands), primer annealing (the primers bind to the single strands) and extension (the polymerase extends the primers). Every strand present acts as a template in the next cycle, so the amount of the target DNA doubles with each cycle.
(a) Why the polymerase must be thermostable
Step 1 — Every cycle begins with heating the DNA to a high temperature to separate its strands (denaturation).
Step 2 — An ordinary DNA polymerase is denatured by this heat, so fresh enzyme would have to be added after every denaturation step.
Step 3 — The enzyme from Thermus aquaticus "remain[s] active during the high temperature induced denaturation", so one addition lasts through all the cycles.
Answer: it must survive the repeated high-temperature denaturation step so that it can extend the primers in every cycle.
(b) Primers
Primers are small, chemically synthesised oligonucleotides (short single-stranded DNA pieces). They must be complementary to the regions of DNA flanking the target segment, one primer for each strand, so that they bind on either side of the region to be copied. The polymerase then extends each primer, using the nucleotides provided and the DNA as template.
Answer: short synthetic oligonucleotides complementary to the regions flanking the target DNA.
(c) Number of copies after 5 cycles
Step 1 — State the rule. With perfect doubling, each cycle doubles the number of double-stranded molecules, so starting from one molecule,
copies after n cycles=2n
Step 2 — Follow the doubling cycle by cycle.
| Cycle | 0 (start) | 1 | 2 | 3 | 4 | 5 |
|---|
| Double-stranded copies | 1 | 2 | 4 | 8 | 16 | 32 |
Step 3 — Check with the formula.
25=2×2×2×2×2=32
Answer: 32 double-stranded copies.
(d) Use of the amplified fragment
NCERT: "The amplified fragment if desired can now be used to ligate with a vector for further cloning." The amplified gene of interest is joined to a cloning vector with DNA ligase to make recombinant DNA.
Answer: it is ligated into a vector for further cloning.
Note: an ordinary DNA polymerase would be denatured by every heating step, starting with the very first, so it would have to be replaced in every cycle; that is why the thermostable Taq polymerase is used.