(a) On the horizontal board, N=mg=5×10=50 N.
The block starts moving at 20 N, so the limiting static friction is 20 N:
μs=5020=0.4
At a steady pull of 15 N the velocity is uniform, so the net force is zero and kinetic friction is 15 N:
μk=5015=0.3
(b) With a 25 N pull the block slides, and kinetic friction of 15 N opposes it:
a=525−15=2 m s−2
(c) On a board tilted at angle θ, the forces are the weight mg, the normal force N and static friction f up the slope.

Perpendicular to the board: N=mgcosθ. Along the board, friction must balance mgsinθ. The block begins to slide when this component reaches the limiting friction:
mgsinθ=μsmgcosθ⇒tanθ=μs=0.4
θ=tan−1(0.4)≈21.8∘
This angle (the angle of repose) does not depend on the mass of the block.
(d) Friction arises at the tiny regions where the surfaces actually touch. When the block is at rest, these regions have time to settle into each other, the small bumps interlock and the contact is strong, so a larger force is needed to start motion. Once the block is sliding, the bumps do not get time to settle and they skip over each other, so less force is needed to keep it moving. Hence fk<(fs)max, that is, μk<μs, as the experiment shows (15 N against 20 N).