A carpenter makes stackable wooden pegs. Each peg starts as a solid cylinder of radius 3 cm and height 10 cm. A cone of radius 3 cm and height 4 cm is carved out of the top face, and the carved-out cone is glued, point outwards, on the bottom face — so the point of one peg fits into the hollow of the next. (Take π=3.14)
(i) Does the volume of wood in the peg change? Give a reason. [1]
(ii) Find the total surface area of the finished peg, and how much it exceeds that of the original cylinder. [2]
(i) Volume.
No. The same cone of wood is removed from the top and added to the bottom, so the volume stays equal to that of the original cylinder:
πr2h=3.14×3×3×10=282.6cm3
(ii) Surface area.
Step 1 — slant height of the cone.
l=32+42=5cm
Step 2 — which surfaces are exposed?
curved surface of the cylinder: 2πrh=2π×3×10=60π
the top face is gone: the cone's base has the same radius as the cylinder, so the whole top circle is cut away and replaced by the inside of the hollow, of area πrl=15π
the bottom face is covered by the glued cone's base; what shows is the cone's curved surface, πrl=15π
TSA=60π+15π+15π=90π=90×3.14=282.6cm2
Step 3 — original cylinder.
2πrh+2πr2=60π+18π=78π=244.92cm2
Step 4 — increase.
90π−78π=12π=12×3.14=37.68cm2
Check: each end swaps a flat circle (9π) for a cone surface (15π), gaining 6π; two ends gain 12π ✓.