Construct the following figure.

How do we construct the petals so that they are of the maximum possible size within a given square?
Confirming your payment
Constructions and Tilings · Question 12 of 25
Construct the following figure.

How do we construct the petals so that they are of the maximum possible size within a given square?

Construction:
(i) Construct a square ABCD (for example of side 6 cm, using angles at A and B and compass to mark equal sides).
(ii) Construct the perpendicular bisectors of the sides AB, BC, CD and DA. Let them cut the sides at their midpoints E, F, G and H. The two bisectors meet at the centre O of the square.
(iii) With centre E and radius EA (half the side, 3 cm), draw the semicircle from A to B inside the square. It passes through O, because OE is also half the side.
(iv) In the same way, with centres F, G and H and the same radius, draw the semicircles B to C, C to D and D to A inside the square.
(v) Rub out the construction lines.

Each petal lies between two of these semicircles and joins a corner of the square to the centre O. For example, the petal at A is bounded by the semicircle with centre E and the semicircle with centre H; both pass through A and O.
Maximum size: a petal cannot go beyond the corner of the square or past the centre, where it meets the other petals. Using radius = half the side makes every petal stretch all the way from a corner to the centre, and each semicircle just touches the two sides of the square at the corners (its diameter is a whole side). A smaller radius would give petals that do not reach the corners, and a larger radius would make the arcs cross the sides of the square. So radius = half the side of the square gives the largest petals.