(i) Start with a cylinder of diameter 6 cm and height 6 cm. Draw a diameter across its top face. Make two flat cuts, one on each side, each going from this diameter down to the edge of the bottom circle. The top becomes a sharp straight ridge 6 cm long, the bottom stays a full circle, and the plug looks like the tip of a flat screwdriver.
(ii) The plug passes snugly through a hole when its profile, seen along the direction it moves, is exactly the shape of the hole.
- Circle: push it through upright, bottom first. Seen from above, its outline is the bottom circle, diameter 6 cm.
- Triangle: push it through on its side, moving along the direction of the ridge. Seen along the ridge, the two cuts look like the slanting sides of a triangle with base 6 cm (the bottom circle seen edge on) and height 6 cm.
- Square: turn it a quarter turn and push it through on its side, moving across the ridge. Seen from this side, the outline is 6 cm wide (the ridge, or the bottom circle seen edge on) and 6 cm tall: a square.
(iii) A plain cylinder has only two kinds of profiles: a circle (seen along its axis) and a rectangle (seen from the side), or shapes with curved edges when seen at a slant. A triangle has slanting straight sides meeting in a sharp corner, and a cylinder has no slanting flat faces to make them.
