Option (C) is correct.
Explanation:
Read the table in two parts.
Low pressures (0.005 to 0.020 kPa): each doubling of p doubles the rate (0.995 → 1.98 → 3.92), so the rate is proportional to p: first order, with
k=prate=0.0050.995×10−4=1.99×10−2 s−1
High pressures (20 to 80 kPa): quadrupling p raises the rate by only 4% (190 → 198), so the rate is practically independent of p: zero order, with the rate close to its limit of about 2.0×10−2 kPa s−1.
The reason is the surface. The reaction takes place only on phosphine molecules adsorbed on the metal. At low pressure only a small part of the surface is covered, and the coverage, and so the rate, is proportional to p. At high pressure the surface is completely covered (saturated), so extra gas cannot react any faster.
At 80 kPa the reaction is zero order, so the time for the first 10 kPa is
t=rateΔp=1.98×10−210=5.1×102 s
(The rate at 70 kPa is still about 1.97×10−2 kPa s−1, so using a constant rate is justified.)

- (A) is wrong: the first-order k from the low-pressure data does not apply at 80 kPa. It would predict a rate of 1.99×10−2×80=1.59 kPa s−1, eighty times the measured 1.98×10−2, and hence a time (2.303/k×log(80/70)=6.7 s) that is far too short.
- (B) is wrong: a single "order" from the two end points averages two different behaviours. The data show that doubling p doubles the rate at low pressure but barely changes it at high pressure; it never multiplies it by 1.46.
- (D) is wrong: the regimes are reversed. The surface is fully covered at high pressure, which gives zero order; and 198×10−4/80=2.5×10−4 s−1 is not a constant, since at 20 kPa the same ratio is 9.5×10−4 s−1.