A cylindrical vessel of radius 7 cm and height 10 cm has a conical cavity of radius 3 cm and depth 4 cm hollowed out from the centre of its top face. What is the total surface area of the remaining solid?
Competency-Based Questions (CBQ) · Question 27 of 80
A cylindrical vessel of radius 7 cm and height 10 cm has a conical cavity of radius 3 cm and depth 4 cm hollowed out…
Question 271 markMCQMedium
Select your answer
(A) 641.14 cm²
(B) 757.43 cm²
- Correct answer
(C) 766.86 cm²
(D) 795.14 cm²
Answer: (C) 766.86 cm²
Step 1 — Find the slant height of the coneThe cavity is a cone of radius cm and depth cm:
Step 2 — Walk around the solid and name every surface
The cone is narrower than the cylinder, so it does not remove the whole top face. Look at each surface in turn:
- the curved surface of the cylinder, all the way round:
- the flat circular bottom, untouched:
- the top face — a circle of radius cm with a circle of radius cm punched out of its middle. What is left is a flat ring, and its area is the big circle minus the small one:
- the inside of the conical hollow, which you can see down into:
Step 3 — Add the four pieces
Why the other options are wrong
-
(A) 641.14 cm² — the flat ring on top was left out, as though the cone had removed the entire top face. It only removes a circle of radius cm.
-
(B) 757.43 cm² — the depth cm was used in place of the slant height cm. The wall of a cone slopes, so always takes the slant height.
-
(D) 795.14 cm² — the whole top circle was counted instead of the ring , so the of area where the hole is got counted even though it is not there.
