A stone pillar consists of a cuboidal base of dimensions 50 cm × 50 cm × 20 cm, with a solid cylinder of radius 14 cm and height 100 cm standing at the centre of the base's top face. The whole pillar is to be polished on the outside, except for the bottom face of the cuboid which rests on the ground. What area has to be polished?
Competency-Based Questions (CBQ) · Question 64 of 80
A stone pillar consists of a cuboidal base of dimensions 50 cm × 50 cm × 20 cm, with a solid cylinder of radius 14 cm…
(A) 15916 cm²
(B) 14684 cm²
(C) 17800 cm²
- Correct answer
(D) 15300 cm²
Answer: (D) 15300 cm²
The safest way to handle a question like this is to list every visible surface one at a time and then add. There are four of them.
Surface 1 — The four side faces of the cuboid
Each is a rectangle cm wide and cm high:
Surface 2 — The top face of the cuboid, minus the circle the cylinder covers
The top face is a square of side cm, but the cylinder stands on part of it. That covered circle is hidden, so take it away:
Surface 3 — The curved surface of the cylinder
Surface 4 — The flat circular top of the cylinder
Add them up
Why the other options are wrong
-
(A) 15916 cm² — the full square top cm² was used instead of cm², so the cm² of floor underneath the cylinder was polished too, even though the cylinder is sitting on it.
-
(B) 14684 cm² — the flat circular top of the cylinder was left out.
-
(C) 17800 cm² — the bottom face of the cuboid ( cm²) was included, but that face is resting on the ground.
